Hirschfeld Plumbing, Heating & Air Conditioning offers exclusive Preventive Maintenance programs to make sure your heating and cooling systems are ready to go for the cold and hot months, respectively.
Sign up for a Preventive Maintenance Plan and get 10% off service parts!
All for just $10 per month!
Sign up for the Hirschfeld Plumbing, Heating & AC Partnership Energy Savings Agreement to get:
|
- Priority Emergency “No Heat” Calls
- 15-point Heating System Tune-Up (see below)
- 15-point Cooling System Tune-Up (see below)
- 10% Discount on Service Parts for Heating System
- Discount Towards Heat Exchangers Failure on Heating System
- Annual Tune-Up to Maximize Efficiency and Reliability for Extended Life
- 10% Discount on Service Parts for Cooling System
- Discount Towards Compressor Failure on Cooling System
- Annual Tune-Up to Maximize Cooling Efficiency and Reliability for Extended Life
ALL FOR JUST $10 PER MONTH! |
15-Point Heating Tune-Up
|
|
15-Point Cooling Tune-Up
|
- Clean burners and inspect heat exchangers
- Clean and adjust thermostat
- Lubricate motors and bearings as needed
- Clean and adjust pilot assembly
- Drain expansion tank or change filters
- Test & adjust pressure regulator
- Test & adjust operation of safety controls
- Inspect flue pipe and/or draft diverter
- Monitor for combustion leakage
- Check blower motor & belt (if applicable)
- Test & tighten all wiring and connections
- Test gas valve operation
- Adjust burner for maximum efficiency
- Turn exposed dampers to “heat” position (no balancing)
- Inform customer of equipment condition, recommend necessary repairs or replacements
|
|
- Lubricate all moving parts (blower motor, etc.)
- Hook-up gauges, record operating conditions
- Close or replace filters
- Measure refrigerant and fine tune efficiency
- Flush condensate drain to prevent overflow
- Clean outdoor condenser coil
- Test temperature drop, adjust blower speed as needed
- Safety test all controls for proper operation
- Test voltage and amperage, check for worn bearings
- Check blower motor & belt (if applicable)
- Test operation & condition of compressor
- Inspect, start & run capacitors and relays
- Tighten & safety test all wiring and connections
- Clean and adjust thermostat for proper operation
- Inform customer of equipment condition, recommend necessary repairs or replacements
|